Posted by Bill
on 7/13/2009, 1:13 pm
192.234.214.110
1963 Chevy II (TRUE SS)
5 inch Fiberglass Glasstek Pin On Hood
Fiberglass Glasstek Trunk Lid
Billet Grille
Aftermarket front Clip
Tubular A-arms
2 inch Drop Spindles with 11 inch Disk Brake Rotors
Flaming River Rack and Pinion
QA1 12 Way Adjustable Coil Overs (ON ALL 4 CORNERS)
Line Lock
Dual Master Cylinder
Weld Pro Stars 15x3 1/2" fronts with Moroso front runners
New - Weld Pro Stars Brand new 2 passes on them 15x12s
New - Hoosier 29.5x10.5x15 slicks 2 passes on them new
New - Moser Axles, Bearings, Seals, 5/8 Studs, Spool, 4.56 Gear 2 passes on them all new
Nodular third member
Narrowed 9 inch 43 inches with Brace and QA1 12 way coil overs
Ladder Bars
Aftermarket Rear frame rails
2 Jaz Fiberglass Seat
5 way RCI Harness Belt
B&M Pro Shifter Not shown in pics but is going.
Fenderwell Hooker 1 3/4" tube headers with EVAC system installed
Carpeted throughout the car
Autometer Water Temp, Oil Press.
Autometer Tach
8 Gallon Fuel Cell
12 point cage plus the two down struts from the engine area on the front clip not a true 14 but does help some.
Fuller Fabrications in Lodi, Ca. helped build this car.
No Engine or Transmission this is a roller. Car weighs 2775 LBS. with a sbc and a glide and goes straight as an arrow with 1.40 60 fts. on the motor
916-248-0370
Please email me with any questions at bill.vandorpe@lc.ca.gov
Thank you,
$8900 OBO
Message Thread:
« Back to thread