Posted by JB(MS) on 8/9/2009, 4:28 pm, in reply to "Re: Cointrax chip went bad........"
66.175.148.151
I took the Cointrax out for a short hunt and found I can run the sensitivity on 2 with no problems except for a little chatter from off to the side of the coil junk targets. Too hot to stay out long but I got about a dollar in clad and dug three deep targets that made the meter jump around in the high coin range. Two of the deep targets were brass nuts, and no idea what the NT thing is. It was at least 10 inches down, my trowel is 10.5 inches long and it was as deep as the trowel is long, the meter was jumping between Zinc, Dime and Quarter and it gave a strong signal in disc mode. Whatever it is it's 2 inches long, the "T" is 1.5 inches tall and it has a place on the back to fasten it to something.
Message Thread:
« Back to thread