NEC Phone System Forum: Re: Caller ID

[ Post a Response | NEC Phone System Forum ]

Re: Caller ID - DS1000/2000

Posted by Bob on October 4, 2007, 2:46 pm, in reply to "Caller ID - DS1000/2000"

It would be very useful for you to download the DS2000 Software Manual, an 800+ page document that covers this and other subjects in step-by-step detail.
After you get to the point where your phone displays Type?Loop Start DTMF, hit the up or down arrow keys until you get to the one for CLID?DSP. If it doesn't say DSP, hit the '1' key and then the HOLD key to change it to that.
Repeat for every trunk line that has caller ID.
Be aware that some phone companies don't provide an adequate caller id signal that the DSP can recognize. If this is the case, you'll have to contact NEC thru your dealer to get caller id daughterboards for your trunk cards.

Link: DS1000/2000 Software Manual (03.2*.**)

Responses:

There are no responses to this message.

« Back to thread

Post a Response

Your Name:

Your Email:

Subject:

Message:

Optional Image URL:

Optional Link Title:
Optional Link URL:

Notify me by email of all message replies.

By posting, you confirm that you have read and agreed to be bound by the board's usage terms.