Posted by Markkw
on September 5, 2008, 14:32:01
71.53.135.178
Got a Husky 360 chainsaw - was running fine, shut it off to move a few branches and it wouldn't start again. Went the whole route with it, spark, air, ect.... wasn't getting gas, found pin hole in pulse line from c-c to carb, repaired same. Now, it's getting gas alright, it's flooding out. I turned the limited adjustment screws for high & low idle all the way closed with no change. Any ideas on a repair or is it to the point of replacing the carb?
Message Thread:
« Back to thread