Posted by Wayne on 7/17/2009, 11:37 pm, in reply to "Re: Trying to get my Bonnie to start & run at low revs!"
86.171.43.90
Thanks for the response Brian 
Have to admit I haven't checked out the float height since fitting the new floats & needle valves - as it isn't flooding I assumed all was well, until I checked the Meriden manual tonight, I didn't realise they were adjustable, will check in the morning.
The reason I changed the floats & valves was because I was getting really bad flooding. Don't think its the timing at fault, it's a boyer micro system, which hasn't been altered since it was last running well, and the motor is aslo very responsive when it is running, so I think the timing is ok?
Will keep you posted with how I get on.
Cheers
Wayne
6
Message Thread:
« Back to thread