The Triumph Bonneville Message Board
[ Post a Response | The Triumph Bonneville Message Board ]
Shropshire Classic Motorcycles for all T140 sparesFrame and cycle parts ,Frame and cycle parts Page 2,Electrical ,Engine parts ,Clutch,Gearbox,Carburetter,Stickers,Tools,
Extras,Front Forks,Brake parts,Engine parts
EBC BRAKE PADS 10% discount to Notice Board users this week!
Re: Steering head bearings
Posted by L.A.B. on 8/1/2009, 7:38 pm, in reply to "Steering head bearings"
82.22.53.127
<<there is a gap of about 1/4" between the surface of the bottom yoke and the bottom bearing.>>
With the lower yoke fitted to the headstock, what distance is there between the base of the headstock and the upper surface of the lower yoke? As the gap should measure up at *around* 1/8" or so?
Did you get the bearings from a Triumph parts supplier, or did you get them from a bearing supplier?
|
Triumph Bonneville home page.Shropshire Classic Motorcycles for all T140 sparesFrame and cycle parts ,Frame and cycle parts Page 2,Electrical ,Engine parts ,Clutch,Gearbox,Carburetter,Stickers,Tools,
Extras,Front Forks,Brake parts,Engine parts
EBC BRAKE PADS 10% discount to Notice Board users this week!
