Posted by Jimmy on 8/24/2009, 9:20 pm
78.150.215.118
A few weeks ago I replaced the pushrod seals on my T140 Bonnie. On the strip down I had to order new tubes so the various parts lay in the garage for a week or so before refitting. Now due to a variety of reasons, not excluding my own lazieness / incompetence, I did not label the pushrods, my thinking being if I left them sitting in the rocker gasket I would know what went where.
Cutting a short story very long they got mixed up.
Over the last few weeks I have noticed a clattering noise coming from the bottom end, mainly at tickover / low revs.
1/ Is the above the reason for this (it wasnt there before)
2/ Will it be ok to run or,
3/ Will I have to get new pushrods, tappets etc, or is it something more sinister
44
Message Thread:
« Back to thread