Back to Forum

Post a Response

Re: Is this Right?

Posted by Steve Thompson on December 8, 2008, 6:44 pm, in reply to "Re: Is this Right?"
Stephen Thompson

We had a 27 year old "technician" who overtightened this type of bearing (taper roller) on 2 seperate occassions. He was "talked through" the fitting procedure but obviously had no comprehension of this type of bearing. If the lads coming through training aren't taught about them what chance the diy-er?

241

---

Message Thread: Is this Right? - Peter Warman December 6, 2008, 1:10 pm Re: Is this Right? - Steve Nicholas December 6, 2008, 1:34 pm Re: Is this Right? - Tom Williams December 6, 2008, 5:50 pm Re: Is this Right? - Graham Bullock December 6, 2008, 10:00 pm Re: Is this Right? - Peter Warman December 7, 2008, 12:50 pm Re: Is this Right? - aidan birley December 7, 2008, 1:10 pm Re: Is this Right? - jmccallum December 7, 2008, 4:38 pm Re: Is this Right? - Peter Warman December 8, 2008, 2:14 pm Re: Is this Right? - Graham Bullock December 8, 2008, 6:34 pm Tyre Pressures - Peter Warman December 10, 2008, 6:52 pm Re: Is this Right? - Steve Thompson December 8, 2008, 6:44 pm Re: Is this Right? - Phil Dunmore December 9, 2008, 10:36 pm Re: Is this Right? - Joe McGeoghan December 11, 2008, 11:00 am Re: Is this Right? - Paul Foster December 12, 2008, 6:00 pm Re: Is this Right? - charles scatchard December 12, 2008, 11:23 pm Re: Is this Right? - Colin Calder December 17, 2008, 5:48 pm Re: Is this Right? - Paul Foster December 18, 2008, 9:51 am « Back to thread

---

Post a Response ( * ) Required

Copyright © uk autotalk
terms & conditions please read