Nissan Primera 2.0 Multipoint 1996Archived Message
Posted by Bill Greer on April 3, 2004, 7:37 pm
Vehicle will not run with Lambda sensor connected. Three wire type. 12 volt heater feed, earth wire and signal wire. When connected 12 volts on earth wire. When earthed separately relay energises and idle stepper motor engages but engine will still not run. When disconnected, will run OK but on the rich side. Not come across this before. Replaced Lambda with genuine one. Only other thing to consider is autoelectrician has recently removed NATS. Could this have an effect? Any ideas please?