Posted by Rob Nicholson on December 8, 2015, 10:59 pm Edited by board administrator March 30, 2016, 2:08 pm
This is a full Hofmann (Snap On) ATL MOT Class IV bay for one man testing. Everything is included Geogas 3000 gas analyser with smoke head (petrol & diesel) Fully auto weighing RBT Roller Brake Tester, Quadralift 4000Kg lift with Hydraulic shaker plates and run up ramps (this is the wide version) Majorlift jacking beam, Headlamp aligner, mirrors, decelerometer, manuals, etc.
The gas analyser uses the same flat panel monitor as the RBT with a remote control or use the keyboard. Thiswas removed from a garage that closed (due to landlords rent increase) by a Snap On employed engineer it has been dry stored for over a year. The engineer is now self employed based around the Reading area He would be happy to fit commission and calibrate this.
This kit also has the bonus of Class I & II upgrade (motorbike) if you can get a few of these through the door it is a sure fire way to earn £100 / hour - a bike test takes literally 10 minutes and £25 seems achievable anywhere
This is only for sale due to renovating a showroom and converting into a workshop but as building costs go it's more cost efective to flatten it and replace with a new building but slightly larger that will allow me to fit in Class VII.
Kit in good condition blue in colour as per link below this would set you back £30K + vat today.
£12000 + vat. A fair deposit would secure until next year, we have a forklift to load at this end, viewing at garage address DN17 4LP
I would accept £11,000 + VAT for this. Kit supplied new in 2010 (ramp is build date 2009) 3 phase, light use and good condition and all guaranteed working.
Apologies link above has been removed. See an example picture (jacking beam is yellow otherwise same)
Re: Deposit taken
Posted by Rob Nicholson on February 19, 2016, 12:34 pm, in reply to "Re: REDUCED"
I will update when paid in full / gone.
SOLD #
Posted by Rob Nicholson on March 25, 2016, 9:13 pm, in reply to "Re: Deposit taken" Edited by board administrator March 30, 2016, 2:08 pm
