Posted by Mick Partington on July 3, 2004, 10:08 pm
1st job fitting Cat 1 to Y reg Saxo VTR, alarm fitted fine, then customer mentioned, Petrol gauge..?. Turn on ign, needle drops to Zero,then rises,drops and rises again, then stays at Zero. (says there is £20 of fuel in it,)been nowhere near clocks,(all work done on pass glovebox area..
2nd Job, Non start VW Golf 1997, 1800Petrol.. Checked 3 pin plug on Dizzy ,Live,earth, live to middle pin,asked customer to crank, with plug unplugged,(Car started...? (Maybe I'm thinking of a different setup, but HOW..!!)
3rd Job Toyota Power van, (Alarm again) Found wire for Door pin switch, neg when open, Pos when close, connected alarm wire to it, and shut door ,,,,Radio comes on,open door, Radio Goes off.
4th job Toyota powervan,(S, 1998) Heater motor removal, Undid every bolt i could see holding Fan housing, still wont bloody come out,