replies Archived Message
Posted by Paul Gunstone on November 7, 2004, 1:53 pm, in reply to "Vauxhall Vectra, MY2000, X18XE1, Simtec 70"
Hi Peter,
You say that you have continuity in the wiring, But as you can appreciate, the very small contacts in the connector blocks can become spread and not make a good contact! Check that all the relevant connectors and pins are a 'Snug' fit. Secondly, check all the wires for 'chaffing' and make sure that they are not inter-connecting within the loom! Last of all, if all this is ok, solder all new earths into the loom of the ECU and fix them directly to the vehicle body! If this then fails to resolve your problems I would suspect the ECU! Might be worth giving ATP a call and have a chat with Mike.
All the best and hope this helps,
Gunner.
|
| Message Thread:
- Vauxhall Vectra, MY2000, X18XE1, Simtec 70 - MAF fault - MIL lamp on - code 110 - Peter Rainsley November 7, 2004, 11:06 am
- replies - Paul Gunstone November 7, 2004, 1:53 pm
- replies - Nick Bell November 7, 2004, 5:26 pm
- replies - andrew parfitt November 7, 2004, 6:02 pm
- fixed - Peter Rainsley November 8, 2004, 4:51 pm
|
|