Renault Kangoo 1999 1.4i Siemens Sirius32 - Non starterArchived Message
Posted by Andrew west on November 13, 2004, 1:50 pm
Does anybody have any pin data for the Siemens Sirius32 sytem on this Kangoo? I've got this one in from another garage who have already checked it through themselves & sent off the Ecu to be checked & it was returned with no faults found. Originally when the garage rang me about it the engine would start & run for a little while,then stop ,now it won't start at all.The fuel pump relay is ok & it's getting a switched feed from the ignition but no earth from the Ecu.When the relay is bridged the pump runs & coil gets powered ,but ecu won't switch coil negative.The crank sensor has already been replaced & is providing a signal when cranked.There is a loom connector on the nearside inner wing which was corroded on a few pins,but after cleaning them it's made no difference. It seems like an ECU fault.The mil isn't coming on when the ignition is switched on & i can't get coms with two different scan tools. Any help would be appreciated,pin data would be a great help. Thanks in advance , Regards Andrew