Back to Forum
Post a Response
    Merc A140 'W' reg Archived Message

    Posted by Dave Stock on May 2, 2008, 10:04 am


    Can anybody help with this one..

    This vehicle appears to be running in Limp. It will not rev above about 3500 rpm.
    The driver ran into a large hole in the road and destroyed drivers side front and rear wheels.

    Fault codes found on arrival were:-
    P0500 Fr. vehicle speed signal implausible
    P0600 CAN from ESP
    C1504 System switched Off. Steering angle sensor not initialised. No Steering angle initialising.

    All faults reset and after driving fault C1504 re-appeared.

    Could this fault cause the vehicle to enter 'Limp' mode.

    Vehicle ran 'OK' before this incident.


    regards
    Dave Stock


    Message Thread:


Copyright © uk autotalk