Petrol Diagnostics

Post a Response

Jaguar X Type 3.0 V6 2002 - Fault code P0180 and P0000, fuel temp sensor - Fixed #

Posted by Simon Forsey on September 27, 2009, 9:39 am

Year of Manufacture *: 2002
Engine Code or Type *: V6 3.0

Hi

Going out to this one on Monday, it has been looked at by at least two other garages.

DTC P0180 Fuel temp sensor faulty, garage changed it for a new on from dealer, also checked wiring back to ECU.

Also has P0000.

Another garage diagnosed it as O2 sensor which they also changed, but with no luck.

I do think this is a fault with the fuel temp sensor, but if the garage has correctly tested the circuits back to th ECU it is possible that it could be an ECU fault. I have not seen an ECU fault with these vehicles but then again I dont see many of them.

Has anyone else seen or heard of this fault?

Regards

Simon

Re: Jaguar X Type P0180 and P000

Posted by Pete Mutlow <iframe src='https://members5.boardhost.com/ukautotalk4/info/user=UKAT1569' width='330' height='300' border=0 style='border:none;'> on September 27, 2009, 2:02 pm, in reply to "Jaguar X Type P0180 and P000"
Peter Mutlow

Hi Simon,

What's wrong with the car? Or have I missed something.

Regards

Pete M

Re: Jaguar X Type P0180 and P000

Posted by Kevin Apps <iframe src='https://members5.boardhost.com/ukautotalk4/info/user=UKAT2589' width='330' height='300' border=0 style='border:none;'> on September 27, 2009, 3:36 pm, in reply to "Jaguar X Type P0180 and P000"
Kevin Apps

Pete.
I will guess here, no driving fault, just mil come,s on most likely on secound or third start after erasing codes.
Kev.

Re: Jaguar X Type P0180 and P000

Posted by Simon Forsey <iframe src='https://members5.boardhost.com/ukautotalk4/info/user=UKAT5231' width='330' height='300' border=0 style='border:none;'> on September 27, 2009, 9:49 pm, in reply to "Re: Jaguar X Type P0180 and P000"

Sorry, my fault.

No driving faults, just MIL on.

Regards

Simon

Fixed #

Posted by Simon Forsey on October 4, 2009, 2:28 am, in reply to "Re: Jaguar X Type P0180 and P000"
Message modified by board administrator October 5, 2009, 11:21 am

I attended this car and was give some more info, the car did start to run bad just before MIL came on. When I scanned it I got code P0191 fuel pressure sensor circuit.

This sensor lives just under the throttle body and has a 3 wire plug. When I put my Pico on I was only getting around half a volt supply. '

After wiggling the wiring above the bell housing the voltage changed. Found that there was a poor connection in the wiring harness plug which when cleaned and refitted the FPS had the correct 5v supply and there for the right signal.

I wish they all went that well!

Regards

« Back to index

[ Petrol Diagnostics ]