Posted by Steve Norman on July 3, 2008, 10:03 pm, in reply to "Re: Land Rover Discovery Rear Diff seal 04 "User logged in as UKAT5548
Steve Norman - Administrator
Hi,
Use an M8 threaded bolt in a slide hammer,
screw it into the flange the pull it out.
Make sure you measure the depth of the exisiting seal so as to put the new seal in to the correct depth.
Suggest you post questions like this in the technical discussion forum.
Regards
Steve
Message Thread 
Land Rover Discovery Rear Diff seal 04 - Scott Neal July 3, 2008, 8:44 pm
« Back to index | View thread »