Posted by Simon ForseySimon Forsey
on June 10, 2010, 8:46 am, in reply to "Re: Vauxhall Omega 3.0 1995 - Will not rev over 3000 rpm, fault code 19 #"
Hi
I tried removing the earth to the CAM sensor but all that did was trigger an 'open' code for that sensor.
The system is a Bosch 2.1.8
Just an added piece of info, this car will respond fine untill it warms up, then DTC will return and the engine feels like it is hitting a 'limiter' again.
Is there any chance that you can scan the wiring and email it?
Regards
Simon
