Re: Fixed #
Posted by Tony Sefton
on July 18, 2013, 8:39 am, in reply to "
Re: Fixed #"
Tony Sefton
When Manufacturers come up with Extortionate prices like these and refuse to sell a small part that you require, look at other models in the range. On this occasion, Just think Almera and you can buy an AFM for as little as £27.00 + vat Exchange from Bosch. ( might be a little more with price increases etc ) You will have to swap the Air temperature sensor over as the Almera doesn't have one but the terminals are there to solder to. We have sold 100,s or may now be into 1000,s of air flow sensors and I always buy the cheapest version as long as it has the correct fitting, I know Bosch state that the sensors are metered to the pipe size etc and should not be swapped but I have not had 1 single complaint of warning lights coming on, lacking power or MOT emissions failure, Which If there was a considerable difference in these sensors then I am sure that we would have some complaints. I have also seen and tried several versions of Aftermarket sensors and never yet seen one that works properly.
|
Message Thread | This response ↓
Nissan Micra K11 1.0 2002 - MIL on, weak mixture? (waveforms) - Fixed # - Malcolm Tripp March 16, 2011, 9:07 pm
- Re: Nissan Micra K11 - Pete Mutlow March 16, 2011, 9:31 pm
- Re: Nissan Micra K11 - Andrew Kevans March 16, 2011, 10:38 pm
- Re: Nissan Micra K11 - Mark Robins March 17, 2011, 8:23 am
- Re: Nissan Micra K11 - Malcolm Tripp March 17, 2011, 9:53 am
- Re: Nissan Micra K11 - paul mccooke March 17, 2011, 10:58 pm
- Re: Nissan Micra K11 - Malcolm Tripp March 24, 2011, 8:32 pm
- Re: Nissan Micra K11 - lee woods March 24, 2011, 9:42 pm
- Re: Nissan Micra K11 - Malcolm Tripp March 25, 2011, 10:03 am
- Re: Nissan Micra K11 - Paul Mccooke March 29, 2011, 9:51 pm
- Re: Nissan Micra K11 - Lee morton April 6, 2011, 2:13 pm
- Re: Nissan Micra K11 - Dave Hill April 7, 2011, 10:50 pm
- Re: Nissan Micra K11 - John Ritchie April 7, 2011, 11:43 pm
- Re: Nissan Micra K11 - Malcolm Tripp April 8, 2011, 8:19 pm
- Fixed # - Malcolm Tripp April 30, 2011, 6:59 pm
- Re: Fixed # - Jim Power July 13, 2013, 12:13 pm
- Re: Fixed # - MALCOLM TRIPP July 16, 2013, 9:02 pm
- Re: Fixed # - Jim Power July 17, 2013, 10:27 pm
- Re: Fixed # - Tony Sefton July 18, 2013, 8:39 am
« Back to index | View thread » |