Back to Forum
Post a Response
    replies Archived Message

    Posted by mark murphy on October 7, 2006, 12:07 pm, in reply to "Re: merc ml270 cdi 2000"

    hi Alan
    codes are as follows
    p1622 injection pump shut off valve
    p1636 electric suction valve ?
    p1403 egr
    the others you were spot on
    i have tried a maf off a c270 that runs ok but don't seem to have signal voltage coming from ECU, hence 2 ECU transplants, symptoms are no power (fail safe mode)& hard start sometimes leave for 10 mins starts fine coolant level light &engine light on permanently oil level light comes on after 20 mins driving -2 liters but oil level ok. I'm pulling my hair out at this stage (jeep only came in for new wishbone)

    Message Thread:


Copyright © uk autotalk