Back to Forum
Post a Response
    Re: Mazda MX6 1993-1994 2.5iV6 JMZGE16F501268930 Archived Message

    Posted by Shaun Dale on December 19, 2007, 11:43 am, in reply to "Re: Mazda MX6 1993-1994 2.5iV6 JMZGE16F501268930"

    Hi Paul,
    Have a look through the UKPOC Forum archives (UK Probe owners club). I found some very good articles that explained it all.
    Sorry I can't find the link at the moment!There was even information on how to fit an external ignition module.
    IIRC there are two parts internally to the distributor, the coil and the sensor/module assembly.
    There is also a mod to the immobiliser wiring as one ignition signal is sent through the immo but loses signal strength on the way.
    From the sound of it I think you will need the sensor/module assembly.
    Word of warning:- when taking the centre screw out of the spindle you will find that the two interupter discs are seperate and only one is keyed to the shaft. Take notes, a photo or mark with a marker pen before disassembly.
    Hope this helps, Shaun

    Message Thread:


Copyright © uk autotalk