- Chrysler Neon 2.0 16v 96 - Non starter - head gasket replaced Archived Message
Posted by Barry Eger on March 16, 2005, 5:32 pm
|
Hi everyone I was called out to this Neon today. Its a non starter. The back ground to it is this, a garage did a cylinder head job on it and it started up OK, but with the Battery warning light on (the alternator had not been touched) so it was driven to an Auto electricians and parked up, after an hour in the car started and was being reversed into a bay when it cut out and hasn't restarted since. I have checked the immobiliser which is working correctly, fuel pressure is spot on, no coil output (12v at coil), with a noid light in the injector plug I get one bright flash then nothing. With KTS on obd I can get eventually no faults found, but I'm not to sure if this is accurate. Below is a jpeg from my pico scope of the signal coming from the crank sensor, can any one tel me if its correct? cos it don't look right to me. Caps has a little info on wave forms on the Neon and it suggests the wave form should be a continuous hall type signal around 8v high. Information seems hard to get on this vehicle any help would be appreciated Thanks Barry
|
| Message Thread:
|