replies Archived Message
Posted by D Jackson on April 15, 2005, 7:04 pm, in reply to "Re: Audi TT quattro 4x4 1999 1.8 Traction controle light on code 01314"
Cheers Gavin
since reading your post i have tried to find a MAP sensor but it does not seem to have one. Autodata says there is a Baro sensor built in the ECU. What is interesting though is that when i code read the engine managemnt systems i kept getting a fault code for MASS AIR FLOW voltage too low, but this code does not put the engine MIL on. Also the only way i can re-set the traction control code is if i go into engine management and re-set the air mass code, then back into ABS systems and now i can re-set the traction cont code. Once re-set i can turn ignition on the ESP light will then go like it should, but as soon as i start the car it then sets the code again and puts the ESP lighjt back on. I have searched the Autodata wiring diagram but nothing shows that the AIR MASS is wired to ESP/ABS ecm. who knows its a funny one.
Cheers
DJ
|
| Message Thread:
- Audi TT quattro 4x4 1999 1.8 Traction controle light on code 01314 - D Jackson April 15, 2005, 1:17 pm
- replies - Gavin Brown April 15, 2005, 5:01 pm
- replies - D Jackson April 15, 2005, 7:04 pm
- replies - Tony Sefton April 15, 2005, 7:21 pm
- replies - D Jackson April 15, 2005, 8:10 pm
- replies - ray April 17, 2005, 9:50 am
- fixed - D Jackson April 17, 2005, 10:07 am
- replies - Neil Webb April 17, 2005, 10:40 am
|
|