Good day Gentlemen. Car lost power and stopped, taking 5 minutes to restart. Fault code P2034 logged which Launch narrates as Crank Position sensor but Autodata describes as Exhaust gas temp sensor S2 B2. Confused? Just a little! CPS fault would seem more likely.
Other code listed is P0335 Ignition coil 'E'. Which coil is this?
Thanks
Andrew

Andrew

A few suggestions

Any code in eobd ?

pull some plugs and see what you scanner reports

probably best idea Try a different scanner.

Cheers Aidan

Hi Andrew, I think they're both the same code unless there are sub-codes to the P2034:

P2034 check SRS system.Air bag signal short after UB
P2034 check SRS system.Air bag signal will cause the engine stop.
P2034 L5 (crankshaft position sensor)(P0335)
P2034 L5 (Crankshaft position sensor)(P0335)
P2034-001 speed meter interrupt,throttle valve malfunction
P2034-002 speed meter interrupt,brake light switch malfunction
P2034-004 speed meter interrupt,touch switch error
P2034-008 speed meter interrupt,brake light switch CAN BUS signal error

Andrew

>>>>Other code listed is P0335 Ignition coil 'E'. Which coil is this? <<<<

EOBD

P0355 is a coil fault
P0335 is a crank sensor fault!


Cheers Aidan

Crank sensor it is then
Thanks