Replies Archived Message
Posted by Andrew west on October 21, 2004, 10:46 pm, in reply to "Re: Proton 1.5 GLS Triple valve 1994 PL1C22ASKPB502642"
Hello Nick,thanks for your reply,i measured the voltage at the sensor as i connected it & it was dropping to zero volts.I measured the resistance of the sensor & applied vacuum with pump & it didn't vary the resistance at all over any of the pins so the sensor is duff unless it is digital frequency type which i don't think it is.
I tried getting a sensor from Andrew Page ,but Steve couldn't get me one,but did tell me that he had spoke to a Proton technician who said that he normally taps the sensor to get it working again(it made no difference to this one).Anyway will try to order a new sensor tomorrow.Proton sensor is approx £85 + vat & the same one from Misubishi is £150 + vat.
Thanks again for your help.
Regards, Andrew
|
| Message Thread:
- Proton 1.5 GLS Triple valve 1994 - Non runner - Andrew west October 20, 2004, 7:54 pm
- Replies - Nick Bell October 21, 2004, 8:42 am
- Replies - Andrew west October 21, 2004, 10:46 pm
- Replies - Nick Bell October 22, 2004, 8:09 am
- Replies - Mike G October 23, 2004, 1:33 am
- Replies - james McCallum October 23, 2004, 3:10 pm
- Replies - Andrew west October 23, 2004, 11:06 pm
- FIXED - Andrew west October 26, 2004, 8:43 pm
- Replies - Mike G October 27, 2004, 1:14 am
- Replies - Andrew west October 27, 2004, 9:56 pm
- Replies - Mike G October 28, 2004, 1:09 am
|
|