Back to Forum
Post a Response
    replies Archived Message

    Posted by john sartain on October 19, 2006, 8:21 pm, in reply to "Re: Mitsubishi Carisma 1.8 GDi 1999 Throttle body"

    Peter,
    i have been reliably informed of the following procedure to try;
    1)remove throttle body.
    2)examine actuator arm attached to throttle plate spindle
    3)2 small magnetic pads should seen bonded to the arm as part of the throttle control mechanism.
    4)these two small magnetic pads are known to detach themselves
    5)rebond magnetic plates with superglue/araldite etc in exactly same position
    hth
    regards john sartain

    Message Thread:


Copyright © uk autotalk