Posted by D jackson on July 4, 2007, 9:49 am, in reply to "Re: update"
Hi Mike
"This is a part number we do not list and officially offer to test "
This isn't sounding good is it mike. Why let your dealers offer a test that can't really be done then?
"it was simply sent to us with the only information 'non runner no outputs from ECU'. Unfortunately we were not able to find out what 'No outputs from ECU' meant , (no relays , no ignition ?)"
It gets worse doesn't it mike, i did tell camco no 5v outputs on pins 6,8,62,55, No comms, no MIL light, no priming of fuel pump and relay. And after all this is the 21st century, i am only a phone call away if they can't remember what i told them
" With regard to the supply question, the external supply (5V sensor supply - for example on pin 55 to the throttle body potentiometer) will appear when the ignition is switched on but will time out in a few seconds so you cannot test the system without the engine running because the system shuts down the external supply after a few seconds unless the crank sensor signal is present. I think this is the problem "